can-bus resistor for LED indicators

25.00 €


*VAT Removed at checkout for Non EEC Members

The solution for annoying error messages in motorcycle models with the CAN-BUS system!

HS CAN-BUS resistor CBW1 with DIP-switch.

Our newly developed CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.

The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.

In addition, a reliability is given. This means:
if the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.

Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.

The CBW1 can also be used on vehicles with original LED turn signal equipment.

The following resistance values ​​can be set:
150 ohms
170 ohms
240 ohms
300 ohms
400 ohms
600 ohms
1200 ohms

Dimensions:
Height = 11mm
Width = 31mm (without straps)
Width = 46mm (with tabs)
Length = 40mm

Cable length = 200mm with pins

Connections:
Yellow = input channel 1 (+)
Orange = output channel 1 (+)
Blue = input channel 2 (+)
Red = output channel 2 (+)
Gray = input mass (-)
Black = output ground (-)

Hints:
• Up to 2 channels (2 LED indicator) can be operated.
• The connection is explained exactly in the operating instructions!

Delivery: 1 piece

Add to Cart:

  • Model: ID1465



♣ British Racer® Motorcycles - Custom and Performance parts - Triumph Accessories - Smitter Mark® Accessories ♣
Contacts: • British Racer Dealers/Franchising: info@britishracer.com/franchising@britishracer.com
Triumph Dealers: triumph@britishracer.com
Phone: +39 380.2608 025 - VAT-ID 01702800671 - C.R.N. TE-154744
Copyright © 2008-2018 British Racer®
British Racer Pictures - All Rights Reserved
Effettua la registrazione a PayPal e inizia ad accettare pagamenti tramite carta di credito immediatamente.